Hello everyone,
I've fixed dark brown tiles on my bathroom floor, but the guys have a bad job with him, and I can white cement in between the tiles look .. and its reality, the whole pattern looks bad ..
I wonder if there's any way I could kind of color-filling cement between the tiles so that the color of the tile blends ... ?
Suggestions for removing these stains from cement tiles?
PLEASE help, I'm here really in a mess.
This articlefrom the:Home improvement and Knowledge Q & A (http://www.86073.com),visit the above web site.
Home improvement and Knowledge Q & A
Decorative Style,Decorative arts,Effect Picture,Interior decoration and Knowledge Q & A
September 5, 2011
How can I paint cement between the tiles?
Tags:
Category:Home Decorating and Remodeling | Commentary:3 | Trackback:0
1.Guest- arlettde It is a product, color and seals at the same time.
Sold in pint bottles. I have a Q-tip carefully paint only between the tiles. (You remember those, it will also seal ... so take your time and care put into the application).
To either Home Depot or Lowes. Look in tile Department.
He says it is the color of grout. But, mortar, and the "white cement" (real name either thin set or mastic) which is basically the same stuff and is in the same way color. - September 5, 2011 Reply this comment
- 2.AngelofDeath
- If as you say, is that the task can finish a poor rake out the joints with a flat screwdriver to clean it thoroughly when the surface was performed. You can buy colored waterproof mortar from most DIY and hardware stores. If the mortar in powder form, it must be water in a container first, then the powder while stirring as you add it until it is creamy with a thick cosistency. Pour this over the tiles with a rubber hammer Squeegy (the type you would use to clean your windows) and secure it distributes the mixture goes into each tile joint. When it dries quickly so that approximately 1 sq. yard work around \\ u200b \\ u200bzu a time. with a sponge and a bucket of water, clean the excess grout and wipe dry with a clean cloth. This should give you a good finish!
As for the removal of the cement with a paint stains that can scratch and a scouring sponge.
Note this is available it should be done to help you prepare for the joining of the above.
Good luck. - September 5, 2011 Reply this comment
- 3.Guest
- If this was only done to get them back, seem set to repeat through the areas with the thin.
If this isn t possible to do the next best thing, you dig the area with the thin set and regrout shows, with the same color of the mortar. You need to get the same brand of mortar or she won t look t same.You simply go get some mortar out of every place and think it will match. Has exactly the same make and color of his ..
The last scenario is the whole floor with a grout stain spot. It works, but is a last resort way to have built the thin.
Take apart any clumps or excess cement with a plastic or wooden scraper.
Cement stains (as long as we talk glazed ceramic tiles), you can place 1 st scrub, dry with a white nylon pad. After this is done, use a mortar and OTC Effervescent tablets cleaner. These you just mix with water, rinse well. Get out of the cement stains before you put any thing to do with the thin and grout.
All the questions you can email me there by my avatar and check my skills. GL Source (s): 20 years in flooring as store owner/installer Answering questions in Decorating & Remodeling Sherlock diamond AC5 flooring? How do i dye dried wheat? for a decoration? In search of mattress four "Y"-shaped arms have? Door name plate, the husband s name may keep women in a stylish design? - September 5, 2011 Reply this comment
- Articles related:
◎welcome to give out your point。